wire closet shelving makeover pantry makeover with wrap around wood shelves, Kitchen Ideas Wire Closet Shelving Makeover Simple Pantry Makeover With Wrap Around Wood Shelves, Kitchen Ideas Photos

Wire Closet Shelving Makeover Simple Pantry Makeover With Wrap Around Wood Shelves, Kitchen Ideas Photos

Related photos in this diagram:

Other recommended diagram ideas:

New Wire Closet Shelving Makeover Photos - I love the wood shelves, thanks for the statistics at the piece for the the front of the cabinets. There's one aspect that would simply trouble the heck out of me though, the top of the door molding at the proper isn’t even with the top of the molding at the panty! The whole thing else, perfections.

Subsequent, it turned into time to truly screw the cabinets in. ?we first connected it at the outer facet (into the drywall anchor) after which used the extent to make certain the brackets were straight.

To build those shelves, i went to my neighborhood hardware / wooden shop and purchases two eight′ lengths of stable pine shelving (sixteen″ deep), and had it reduce into 32″ lengths (the width of our closet). ?i also purchases two 8′ lengths of 1×2 to use as the shelf help brackets on each aspect; after which two eight′ lengths of a thin trim board to beef up the appearance up the shelves alongside their fronts.

We predrilled and added screws to the 1×2 – as you may see inside the corner. ?that screw is on an attitude because we wanted to screw it into the stud in the nook of the closet wall. ?the opposite screw is hidden however you may see it peaking out below my husbands proper thumb within the photo under:.

Hubs used a level and marked on the wall in which the shelves could cross. ?we used pieces of 1×2 that had been cut to the period that we desired the shelves to be (intensity). ?we used our mitre saw to make the cuts, but you could use any noticed, even a hand saw to reduce these pieces to length. We also used drywall filler, a putty knife, dap, our caulking gun, our (dad’s) nail gun and air compressor, 1.5″ timber screws, a small stage, our drill, and our mitre saw. ?for painting, i used kilz primer and simply white paint by benjamin moore. I painted one coat of primer and coats on each aspect of the pine cabinets that i purchased at the hardware shop – i used our dining room table with a drop cloth as a surface, and used a foam roller. ?it dried pretty fast so i was capable of paint one side, dry, turn it and paint the other side, and so on. ?in a reasonably brief period of time. I didn’t paint the rims of the pine because i didn’t need them to get thicker and no longer suit within the closet properly – and at the the front we have been going to be putting a facing so it didn’t need to be painted.