Advertisement
how to wire a light bar on a truck Wiring Harness, 40-50”, Light, for Razor Series Light Bars 10 New How To Wire A Light, On A Truck Pictures

10 New How To Wire A Light, On A Truck Pictures

Related photos in this diagram:

Other recommended diagram ideas:

How To Wire A Light, On A Truck - With the headliner free from the b-pillar, chris changed into in a position to pull the headliner faraway from the roof sufficient to get admission to all of the important brackets for the curtain airbags and get sufficient room to drill the holes for the n-fab brackets themselves. Chris began through getting rid of the airbag bracket nearest the windshield and labored his way again from there. As soon as jay had the plate geared up, he set to work strolling the switch wiring over to the right region. The most effective snag we ran into become that there wasn't quite enough wiring to make it over to the transfer region. Jay had to increase the harness a chunk via splicing in some lengths of twine.

Even with out the 2 mounting tabs, the plate match lower back in tight and cushty and our new switches looked outstanding. All jay needed to do now changed into hook the light bar's spades onto our battery, and we had been prepared to rock. After he finished with the coat hangar mounts, chris popped off the "airbag" buttons at the b-pillar which hide screws. Then he labored across the b-pillar cowl with a screwdriver to pop its clips and remove it from the pillar itself.

The quit result is pretty notable, and our truck looks even better and now lighting fixtures up the night time like nearly nothing else. A huge thanks over to chris, jay, and every person over at excessive for giving us a hand!. Then the drilling, which took pretty a chunk of effort. There may be quite a few metal underneath those rain gutters and it takes a heck of a drill and drill bit to get thru. Luckily, the guys over at extreme are well-equipped and chris set to work.

We decided to mount our transfer for the mild bar and starkey backup mild kit (more on that later) at the silver panel with the headlight controls. The panel is held in by means of clips and pretty effortlessly pops off. Jay had to disconnect the headlamp knob so as to pull it out. Jay fast reconnected it to get the truck to stop dinging at us.