Advertisement
how to wire a light bar on a jeep jk Light, Install, Where To Hide Wiring?, Jeep Wrangler Forum 13 Professional How To Wire A Light, On A Jeep Jk Solutions

13 Professional How To Wire A Light, On A Jeep Jk Solutions

Related photos in this diagram:

Other recommended diagram ideas:

How To Wire A Light, On A Jeep Jk - Couldn’t get it to work. ?the wire lead from the bar could be very thick and avoided the bracket bolts from threading. ?we determined to smartly run the cord down the windshield facet of the bracket and comfy it using some silicone adhesive.

The kit comes with some more hardware that isn't always wished on this set up. ?handiest the small allen head bolts and washers are wished, we used unique bolts and larger washers to offer a higher clamping area.

Wiring accessories on a jk continually proves an adventure. ?at the inside the sprint is so tightly assembled making sneaking wires around a undertaking and finding a wire to tap into for energy is simply as tough. ?at the engine compartment aspect there may be minimal room and locating a perfect region for items is almost as same of a venture because the interior.

To get the wiring under the hood we removed the 2 bolts that preserve the upper cover panel and snaked the wires beneath. ?be aware: preserve the wires to the rear and make sure there may be no hazard for the wires rubbing. ?luckily the panel has flat edges so the installation is smooth.

A small trouble we ran in to is the bar’s wire is about 1 foot too short. ?this induced the twine connection to the harness to be uncovered out of doors of the jeep. ?we wiped clean up the whole installation with some plastic twine loom.

On this set up we removed the jeep’s glove container which is without difficulty achieved via squeezing in on the rear facets of the box when open. ?at the back of the box is broadly speaking hvac stuff and there may be a small patch of exposed firewall. ?we drilled a small hole at once above the bolt near the battery. ?we then established a small grommet and passed the switch twine and a wonderful lead via the grommet. The lifetime brackets by using hyline are nicely made and include rubber backing to defend the jeep’s paint. ?installing the hyline bar mounts simplest calls for disposing of the 6 torx bolts from the windshield plates and carefully installing the rubber backing and bracket on pinnacle of the plate/windshield. ?reinstall the manufacturing unit bolts but go away semi-loose until the whole thing is established. ?repeat on the other facet.