Advertisement
how to install a ceiling fan and light dimmer switch Ceiling, Dimmer Switch Best Of, Light Wiring Diagram Australia Save Dimmer Switch Wiring Diagram 6 Professional How To Install A Ceiling, And Light Dimmer Switch Collections

6 Professional How To Install A Ceiling, And Light Dimmer Switch Collections

Related photos in this diagram:

Other recommended diagram ideas:

How To Install A Ceiling, And Light Dimmer Switch - The photo beneath left comes from a fan pace controller - that is what desires to be used on a ceiling fan. ?the photograph beneath right comes from a general dimmer transfer, which ought to now not be used to manipulate the motor on a ceiling fan.

The reason for the crimson and yellow is that this is virtually two switches. The yellow is in your mild and the pink is to your fan. There is for each, ought to you need to three-way both.

Use a screw driver again to loosen the screws protecting the electric wires on the aspect of the switch, after which detach the wiring from the transfer. Pay near attention to the cord colors and wherein they have been connected on the old switch, as they will be vital within the subsequent step. Maintain the wires separated via bending them to opposite corners of the container. If the transfer is grounded, do away with the grounding cord last.

Trendy dimmer switches must in no way be used to manipulate the fan motor on a ceiling fan because the dimmer should damage the fan motor, or overheat and begin a hearth. ?to realize whether or not a dimmer transfer is supposed to be used with a fan, just remove the switch cover; there is generally excellent print right at the front of the switch saying whether or not it could be used with a ceiling fan.

The seize right here isn't the three-way setup, however how you will get hots to the container. You want one hot for the light, one for the transfer and your neutral. Assuming you do, you may take the yellow wires and connect them to the white and purple that the preceding 3-manner used.

Turn off the energy to the circuit at the circuit breaker or fuse container. Double test to make sure that it was turned off by using flipping the transfer in an try and perform a light, and by means of using a voltage tester to verify that the wires in the field are not charged as soon as the transfer plate has been eliminated.