honeywell 6 wire thermostat wiring diagram 6 Wire Thermostat Wiring Diagram, Wiring Library 9 Most Honeywell 6 Wire Thermostat Wiring Diagram Ideas

9 Most Honeywell 6 Wire Thermostat Wiring Diagram Ideas

Related photos in this diagram:

Other recommended diagram ideas:

9 Most Honeywell 6 Wire Thermostat Wiring Diagram Ideas - Final, i driven the wires and connectors thru the hollow within the wall plate, installed 2 aaa alkaline batteries within the thermostat and then re-installed the front face of the thermostat taking care to align the two elements well in order that the pins from the circuit board go into the holes within the bus.

Now comes the elaborate component - connecting the wires! Please note that the wires from the wall will possibly vary from producer to producer, even though from what i have study, the pink, white and yellow wires seem to be standardized to the functions proven within the desk under.

My 2014 flagstaff 27rlws travel trailer was geared up from the manufacturing facility with an analog coleman-mach thermostat. We observed that it did no longer control the temperature swings above and underneath the set-factor to our pride. The rv warmed up an excessive amount of earlier than the ac kicked in and in the cooler climate, the temps might drop too low before the furnace came on. Which means that a thermostat improve become in my destiny.

I made sure that the mode transfer (heat / off / cool) at the thermostat become set to "off" earlier than i flipped the breakers returned to the on role and tested the functions of the ac and furnace. I needed to press the right hand up and down buttons to pressure the ac and furnace come on for the reason that programming changed into no longer but done. The whole thing appeared to paintings excellent.

As you could see from my pix, i have linked four of the 5 wires, based on the obvious w to w, r to r, and so forth and many others markings. I do not recognise if i want to hook up the black. I'm nearly sure that the cause i do not have the ac unit kicking on, is due to the two cord crimson and white no longer being connected. Long tale brief, after uninteresting 2 holes (2 tries) i determined the transfer could not cross at the bottom on this thermostat so it needed to pass on the the front face, which means i had to orient the transfer connectors in order that they're vertically above each other - the handiest way it'll fit inside the narrow space at the facet of the the front face. For me, up could suggest excessive speed at the same time as down would imply low velocity.